Broken two reasons leading to the wheel
Date: 2012-06-08
First, the linear velocity is too big wheel1, when the rotational speed of the wheel shaft is too high, control wheel shaft speed to achieve their desired comply with the requirements of the processing speed.2, wheel diameter is too large .. Date: 2012-06-08

 First, the linear velocity is too big wheel

 1, when the rotational speed of the wheel shaft is too high, control wheel shaft speed to achieve their desired comply with the requirements of the processing speed.
2, grinding wheel diameter is too largeWheel diameter is too big line speed will be big, this time to rationally adjust the wheel speed, to match processingRequirements; or using smaller diameter grinding wheel to be processed.
Second, the work is often caught between the grinding wheel and the workpiece holder
1, there is no established side grinding workpiece carrier side grinding is performedFlat-shaped grinding wheel ban for side grinding wheel side grinding bowl should be used for processing. To correctTo set up workpiece holder.
2, the workpiece holder and the workpiece support wheel adjustment bad interval between these two sides to adjust to less than 3 mm, the gap is too large will cause the workpiece card phenomenon. Unfortunately, it would cause the wheel to break.

 3, between the workpiece and the workpiece support tough load wheel support of the workpiece by the workpiece holder can not be tough mount between the grinding wheel and workpiece holder.